Hello everybody.I made a tube and pipe design in Autodesk inventor that contains 2 manifolds and several pipes(want to run a laminar flow simulation).
When i transfer the file to comsol via livelink for inventor, the inside domain is empty of course, so i used the cap faces to define the inside.However, when i try to set the inlet/outlet condition, i cannot select the cap faces.It is like they do not exist as a numbered face.
Thanks in advance.
When i transfer the file to comsol via livelink for inventor, the inside domain is empty of course, so i used the cap faces to define the inside.However, when i try to set the inlet/outlet condition, i cannot select the cap faces.It is like they do not exist as a numbered face.
Thanks in advance.