Hi all,
I'm calculating the magnetic field distribution of a system, which mainly consists of bus bars as shown in the attachment. (The model is imported into COMSOL via the LiveLink interface.) Since the bus bars are relatively thin, we want to use a swept mesh in order to reduce the degrees of freedom. However, the swept mesh doesn't work well because some parts of bus bars touch. Then, how can I generate an efficient mesh? Note that, there are some holes on the bus bars, and the busbars are surrounded by an air box. Thanks in advance.
Regards,
Tony
I'm calculating the magnetic field distribution of a system, which mainly consists of bus bars as shown in the attachment. (The model is imported into COMSOL via the LiveLink interface.) Since the bus bars are relatively thin, we want to use a swept mesh in order to reduce the degrees of freedom. However, the swept mesh doesn't work well because some parts of bus bars touch. Then, how can I generate an efficient mesh? Note that, there are some holes on the bus bars, and the busbars are surrounded by an air box. Thanks in advance.
Regards,
Tony