We need to run the simulation iteratively in Comsol, which means we need the result of the first simulation as an input of the second simulation. Since the number of iteration is quite high, we have used Comsol with Matlab to run the iteration automatically and it works quite well. The only problem here is the simulation is too slow. So we try to use parametric sweep now, because the geometry and mesh has to be only generated once for the entire calculation, unlike previously in Comsol with Matlab, the geometry and mesh is generated in every iteration and it is very time-consuming. But in parametric sweep it seems that the values of all the parameters have to be given before we run the simulation. What we wish is that we can set the value of the second parameter after the simulation with the first parameter. Is it possible in Comsol?
↧